Ipv6 Unicast-Routing; Ping Ipv6 - Enterasys SECURESTACK C3 Configuration Manual

ipv6 unicast-routing

Usage
The default distance is used when no distance is specified in the ipv6 route command. Changing
the default distance does not update the distance of existing static routes, even if they were
assigned the original default distance. The new default distance will only be applied to static
routes created after invoking the ipv6 route distance command.
Use the no form of this command to return the default distance to 1.
Example
This command sets the default distance value to 3.
C3(su)->router(Config)# ipv6 route distance 3
ipv6 unicast-routing
This command enables/disables forwarding of IPv6 unicast datagrams.
Syntax
ipv6 unicast-routing
no ipv6 unicast-routing
Parameters
None.
Defaults
Disabled.
Mode
Router global configuration: C3(su)‐>router(Config)#
Usage
Use this command to enable forwarding of IPv6 unicast datagrams on the SecureStack C3. Use the
no form of the command to disable forwarding of IPv6 unicast datagrams.
Example
This command enables forwarding of IPv6 unicast datagrams on the router.
C3(su)->router(Config)# ipv6 unicast-routing

ping ipv6

Use this command to test routing network connectivity by sending IP ping requests.
Syntax
ping ipv6 ipv6-addr [size num]
22-6 IPv6 Configuration