Enterasys SECURESTACK C3 Configuration Manual page 194

show linkflap
Parameters
globalstate
portstate
parameters
metrics
portsupported
actsupported
maximum
downports
action
operstatus
threshold
interval
downtime
currentcount
totalcount
timelapsed
violations
port‐string
Defaults
• If not specified, information about all link flap detection settings will be displayed.
• If port‐string is not specified, information for all ports will be displayed.
Mode
Switch mode, read‐only.
Usage
The linkflap default conditions are shown in the following table.
Linkflap Parameter
Linkflap global state
Linkflap port state
Linkflap action
Linkflap interval
Linkflap maximum allowed link downs per 10 seconds
Linkflap threshold
(number of allowed link down transitions before action is taken)
7-26 Port Configuration
Displays the global enable state of link flap detection.
Displays the port enable state of link flap detection.
Displays the current value of settable link flap detection parameters.
Displays linkflap detection metrics.
Displays ports which can support the link flap detection function.
Displays link flap detection actions supported by system hardware.
Displays the maximum allowed linkdowns per 10 seconds supported
by system hardware.
Displays ports disabled by link flap detection due to a violation.
Displays linkflap actions taken on violating port(s).
Displays whether linkflap has deactivated port(s).
Displays the number of allowed link down transitions before action is
taken.
Displays the time period for counting link down transitions.
Displays how long violating port(s) are deactivated.
Displays how many linkdown transitions are in the current interval.
Displays how many linkdown transitions have occurred since the last
reset.
Displays the time period since the last link down event or reset.
Displays the number of link flap violations since the last reset.
(Optional) Displays information for specific port(s).
Default Condition
Disabled
Disabled
None
5
20
10