Ipv6 Route - Enterasys SECURESTACK C3 Configuration Manual

ipv6 route

Parameters
hops
Defaults
The default maximum number of IPv6 hops is 64.
Mode
Router global configuration: C3(su)‐>router(Config)#
Usage
This command sets the value of the hop limit field in IPv6 packets originated by this device. This
value is also placed in the "Cur Hop Limit" field of router advertisements generated by this router.
Use the no form of this command to reset the limit to the default value.
Example
This example sets the hop limit to 50.
C3(su)->router(Config)# ipv6 hop-limit 50
ipv6 route
This command configures static IPv6 routes.
Syntax
ipv6 route ipv6-prefix/prefix-length interface {tunnel tunnel-id | vlan vlan-id}
next-hop-addr [pref]
no ipv6 route ipv6-prefix/prefix-length interface {tunnel tunnel-id | vlan vlan-
id} next-hop-addr [pref]
Parameters
ipv6‐prefix/prefix‐length
interface
tunnel-id | vlan
vlan-id
22-4 IPv6 Configuration
Specifies the maximum number of IPv6 hops used in IPv6 packets and
router advertisements generated by this device. Value can range from 1
to 255. The default value is 64.
The IPv6 network prefix that is the destination of the static route, and
the prefix length.
The prefix must be in the form documented in RFC 4291, with the
address specified in hexadecimal using 16‐bit values between colons.
The prefix length is a decimal number indicating the number of high‐
order contiguous bits of the address that comprise the network
portion of the address.
Specifies the interface type and ID of direct static routes from point‐to‐
tunnel
point and broadcast interfaces.