set snmp user
Parameters
user
remote remoteid
encryption des |
aes
privacy privpassword (Optional) Specifies an encryption password. Minimum of 8 characters.
authentication md5
| sha
authpassword
volatile |
nonvolatile
Defaults
If remote is not specified, the user will be registered for the local SNMP engine.
If encryption is not specified, no encryption will be applied.
If authentication is not specified, no authentication will be applied.
If storage type is not specified, nonvolatile will be applied.
Mode
Switch command, read‐write.
Usage
Although all the parameters except for the user name are optional, if you are entering any of the
optional parameters, it is recommended that you enter them in the order shown in the syntax
statement.
Examples
This example shows how to create a new SNMP user named "netops". By default, this user will be
registered on the local SNMP engine without authentication
user will be stored in permanent (nonvolatile) memory:
C3(su)->set snmp user netops
This example creates a new SNMP user named "admin" with DES encryption and MD5
authentication required. The encryption password is "admintest1" and the authentication
password is "admintest2." By default, this user will be registered on the local SNMP engine and
entries related to this user will be stored in permanent (nonvolatile) memory.
C3(su)->set snmp user admin encryption des privacy admintest1 authentication md5
admintest2
8-10 SNMP Configuration
Specifies a name for the SNMPv3 user.
(Optional) Registers the user on a specific remote SNMP engine.
(Optional) Specifies the encryption type for this user.
AES refers to the Advanced Encryption Standard using a 128 bit key size.
Required if encryption is specified.
(Optional) Specifies the authentication type required for this user as MD5
or SHA.
(Optional) Specifies a password for this user when authentication is
required. Minimum of 8 characters.
(Optional) Specifies a storage type for this user entry.
and encryption. Entries related to this