Show Ipv6 Ospf Interface Command Output Details - Enterasys SECURESTACK C3 Configuration Manual

Stackable switches
Hide thumbs Also See for SECURESTACK C3:
Table of Contents

Advertisement

Authentication Type
Metric Cost
OSPF Mtu-ignore
OSPF Interface Type
State
Designated Router
Backup Designated Router
Number of Link Events
This example displays information about tunnel interface 0. Table
content of the output fields.
C3(su)->router#show ipv6 ospf interface tunnel 0
IPv6 Address
ifIndex
OSPF Admin Mode
OSPF Area ID
Router Priority
Retransmit Interval
Hello Interval
Dead Interval
LSA Ack Interval
Iftransit Delay Interval
Authentication Type
Metric Cost
OSPF Mtu-ignore
OSPF Interface Type
State
Designated Router
Backup Designated Router
Number of Link Events
Table
25‐7 provides an explanation of the command output.
Table 25-7 show ipv6 ospf interface Command Output Details
Output Field
IPv6 Address
ifIndex
OSPF Admin Mode
OSPF Area ID
Router Priority
Retransmit Interval
Hello Interval
Dead Interval
LSA Ack Interval
Iftransit Delay Interval
Authentication Type
None
10
Disable
broadcast
designated-router
2.2.2.2
0.0.0.0
2
FE80::5000:2
456
Enable
0.0.0.0
1
5
10
40
1
1
None
1
Disable
point-to-point
point-to-point
0.0.0.0
0.0.0.0
1
What It Displays...
The IPv6 address of the interface.
The interface index number associated with the interface.
Whether the admin mode is enabled or disabled.
The area ID associated with this interface.
The router priority. The router priority determines which router is
the designated router.
The frequency, in seconds, at which the interface sends LSA.
The frequency, in seconds, at which the interface sends Hello
packets.
The amount of time, in seconds, the interface waits before
assuming a neighbor is down.
The amount of time, in seconds, the interface waits before sending
an LSA acknowledgement after receiving an LSA.
The number of seconds the interface adds to the age of LSA
packets before transmission.
The type of authentication the interface performs on LSAs it
receives.
show ipv6 ospf interface
(computed)
25‐7 on page 25‐39 explains the 
(computed)
SecureStack C3 Configuration Guide 25-39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents