Table of Contents
Advertisement
traceroute ipv6
Use this command to discover the routes that packets actually take when traveling to their
destination through the network on a hop‐by‐hop basis.
Syntax
traceroute ipv6 ipv6-addr
Parameters
ipv6‐addr
Defaults
None.
Mode
Switch mode, read‐write.
Usage
This command is also available in router mode.
Example
This example shows how to use traceroute to display a round trip path to host
2001:0db8:1234:5555
C3(su)->router#traceroute ipv6 2001:0db8:1234:5555::1
Traceroute to 2001:0db8:1234:5555, 30 hops max, 40 byte packets
1 2001:0db8:1234:5555
Specifies a host to which the route of an IPv6 packet will be traced. Enter the
address in the form documented in RFC 4291, with the address specified in
hexadecimal using 16‐bit values between colons.
1.000000e+00 ms
1.000000e+00 ms
1.000000e+00 ms
SecureStack C3 Configuration Guide 21-9
traceroute ipv6
- Quick Links:
- Set Ip Address
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SECURESTACK C3 and is the answer not in the manual?
Questions and answers