Show Ipv6 Ospf Abr; Show Ipv6 Ospf Abr Output Details - Enterasys SECURESTACK C3 Configuration Manual

show ipv6 ospf abr

Table 25-2 show ipv6 ospf area Output Details (Continued)
Output Field
Area LSA Checksum
Stub Mode
Import Summary LSAs
OSPF Stub Metric Value
show ipv6 ospf abr
This command displays OSPFv3 routes to reach area border routers.
Syntax
show ipv6 ospf abr
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)‐>router#
Example
This example shows how to display OSPFv3 area border router information.
C3(su)->router# show ipv6 ospf abr
Type
----- -------------- ---- ------------ -------------------------------- --------
INTRA 82.15.0.1
Table 25‐3 provides an explanation of the command output.
Table 25-3 show ipv6 ospf abr Output Details
Output Field
Type
Router ID
Cost
Area ID
25-32 OSPFv3 Configuration
Router Id Cost
10 0.0.0.10
What It Displays...
Number representing the Area LSA Checksum for the specified
Area ID excluding the external (LS type 5) link-state
advertisements.
Whether the specified area is a stub area or not. The possible
values are enabled and disabled. This is a configured value.
Whether to import summary LSAs (enabled or disabled).
Metric value of the stub area. This field displays only if the area is
a configured as a stub area.
Area ID
FE80::200:2DFF:FEE6:FB6B
What It Displays...
The type of the route to the destination, which is one of the
following values:
INTRA — Intra-area route
INTER — Inter-area route
Router ID of the destination.
Cost of using this route.
The area ID of the area from which this route is learned.
Next Hop Next Hop
Intf
Vlan 48