Show Ipv6 Ospf Area; Show Ipv6 Ospf Area Output Details - Enterasys SECURESTACK C3 Configuration Manual

Table 25-1 show ipv6 ospf Output Details
Output Field
Always
Metric
Metric Type

show ipv6 ospf area

This command displays information about the specified OSPFv3 area.
Syntax
show ipv6 ospf area areaid
Parameters
areaid
Defaults
None.
Mode
Router privileged execution: C3(su)‐>router#
Example
This example shows how to display OSPFv3 information for area 20.
C3(su)->router>show ipv6 ospf area 20
AreaID
External Routing
Spf Runs
Area Border Router Count
Area LSA Count
Area LSA Checksum
Stub Mode
Table 25‐2
Table 25-2 show ipv6 ospf area Output Details
Output Field
AreaID
External Routing
Spf Runs
Area Border Router Count
Area LSA Count
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
provides an explanation of the command output.
What It Displays...
Whether default routes are always advertised.
The metric for the advertised default routes. If the metric is not
configured, this field is blank.
Whether the routes are External Type 1 or External Type 2.
0.0.0.20
Import NSSAs
7
0
5
188094
Disable
What It Displays...
Area ID of the requested OSPFv3 area.
The external routing capabilities for this area.
Number of times that the intra-area route table has been
calculated using this area's link-state database.
Total number of area border routers reachable within this area.
Total number of link-state advertisements in this area's link-state
database, excluding AS External LSAs.
show ipv6 ospf area
SecureStack C3 Configuration Guide 25-31