mdi
mdix
port‐string
Defaults
If port‐string is not entered, all ports on the switch are configured.
Mode
Switch command, read‐write.
Usage
By default, Enterasys Networks switch devices are configured to automatically detect the cable
type connection, straight through (MDI) or cross‐over (MDIX), required by the cable connected to
the port. You can configure ports to only use MDI or MDIX connections with this command.
This command only configures Ethernet ports, and cannot be used to configure combo ports on
the switch.
Example
This example configures ports ge.1.1 and ge.1.2 to use MDIX mode.
C3(su)->set port mdix mdix ge.1.1-2
Configure ports to use MDI mode only.
Configure ports to use MDIX mode only.
(Optional) Specify the port or ports to configure.
SecureStack C3 Configuration Guide 7-21
set port mdix