Set Lldp Tx-Interval - Enterasys SECURESTACK C3 Configuration Manual

softphone‐voice
video‐conferencing
streaming‐video
video‐signaling
port‐string
Defaults
If port‐string is not specified, only non‐default values will be displayed for all ports that have non‐
default values configured.
If a port‐string is specified, then all values, default and non‐default, are displayed for the specified
ports.
Mode
Switch command, read‐only.
Example
This example shows how to display all LLDP network policy information for ge.1.1.
C3(ro)->show lldp port network-policy all ge.1.1
Ports
-------
ge.1.1

set lldp tx-interval

Use this command to set the time, in seconds, between successive LLDP frame transmissions
initiated by changes in the LLDP local system information.
Syntax
set lldp tx-interval frequency
Parameters
frequency
Displays information about only the softphone voice application
type.
Displays information about only the video conferencing
application type.
Displays information about only the streaming video application
type.
Displays information about only the video signaling application
type.
(Optional) Displays information about LLDP network policy for
one or a range of ports.
Application
---------------------
voice
voice signaling
guest voice
guest voice signaling
softphone voice
video conferencing
streaming video
video signaling
Specifies the number of seconds between transmissions of LLDP
frames. Value can range from 5 to 32,768 seconds. The default is 30
seconds.
State Tag
-------- --------
enabled untagged
enabled untagged
enabled untagged
enabled untagged
enabled untagged
enabled untagged
enabled untagged
enabled untagged
set lldp tx-interval
Vlan-Id Cos Dscp
------- --- ---
1 0 0
1 0 0
1 0 0
1 0 0
1 0 0
1 0 0
1 0 0
1 0 0
SecureStack C3 Configuration Guide 6-23