Ip Dvmrp; Ip Dvmrp Enable - Enterasys SECURESTACK C3 Configuration Manual

ip dvmrp

Table 20-1 Commands to Enable DVMRP on an Interface
To do this...
Globally enable IGMP.
Globally enable DVMRP.
Enable IGMP on each interface.
Enable DVMRP on each interface .
ip dvmrp
Use this command to enable the DVMRP process. The no form of this command disables the
DVMRP process:
Syntax
ip dvmrp
no ip dvmrp
Parameters
None.
Defaults
None.
Mode
Global configuration: C3(su)‐>router(Config)#
Example
This example shows how to enable the DVMRP process:
C3(su)->router(Config)#ip dvmrp

ip dvmrp enable

Use this command to enable DVMRP on an interface. The no form of this command disables
DVMRP on an interface:
Syntax
ip dvmrp enable
no ip dvmrp enable
Parameters
None.
Defaults
None.
20-34 IPv4 Routing Protocol Configuration
Use these commands...
"ip igmp" on page 13-10
"ip dvmrp" on page 20-34.
"ip igmp enable" on page 13-11
"ip dvmrp enable" on page 20-34