Ipv6 Ospf Areaid; Ipv6 Ospf Cost - Enterasys SECURESTACK C3 Configuration Manual

ipv6 ospf areaid

Example
This example enters router interface configuration mode for VLAN 7 and then enables OSPFv3 on
the interface.
C3(su)->router(Config)# interface vlan 7
C3(su)->router(Config-if(Vlan 7))# ipv6 ospf enable
ipv6 ospf areaid
This command sets the OSPFv3 area to which the router interface belongs.
Syntax
ipv6 ospf areaid areaid
no ipv6 ospf areaid areaid
Parameters
areaid
Defaults
None.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Usage
The area ID uniquely identifies the area to which the interface connects. Assigning an area ID
which does not exist on an interface causes the area to be created with default values.
Use the no form of this command to remove an area from the interface.
Examples
This example assigns VLAN 7 to area 20, expressed in dotted‐quad format.
C3(su)->router(Config)# interface vlan 7
C3(su)->router(Config-if(Vlan 7))# ipv6 ospf areaid 0.0.0.20
This example assigns VLAN 7 to area 20, expressed as a decimal number.
C3(su)->router(Config-if(Vlan 7))# ipv6 ospf areaid 20

ipv6 ospf cost

This command configures the cost of sending a packet on an OSPFv3 interface.
Syntax
ipv6 ospf cost cost
no ipv6 ospf cost cost
25-22 OSPFv3 Configuration
Specifies the area ID in either 32‐bit dotted‐quad format or as a decimal
number between 0 and 4294967295.