Show Ipv6 Ospf Neighbor - Enterasys SECURESTACK C3 Configuration Manual

show ipv6 ospf neighbor

Table 25-8 show ipv6 ospf interface stats Output Details
Output Field
Invalid OSPF Packet Type
Packet Type / Sent / Received
show ipv6 ospf neighbor
This command displays information about OSPFv3 neighbors.
Syntax
show ipv6 ospf neighbor [interface {vlan vlanid | tunnel tunnelid}] [neighborid]
Parameters
interface
vlan vlanid
tunnel tunnelid
neighborid
Defaults
When no parameters are specified, information about all neighbors is displayed.
Mode
Router privileged execution: C3(su)‐>router#
Usage
If you do not specify a neighbor router ID, the output displays summary information in a table. If
you specify an interface or tunnel, only the information for that interface or tunnel displays.
When you specify a neighbor by router ID, detailed information about the neighbor displays.
The information is displayed only if OSPFv3 is enabled and the interface has a neighbor.
Examples
This example illustrates the summary information displayed when no neighbor is specified.
C3(su)->router#show ipv6 ospf neighbor
Router ID
----------------
3.3.3.3
6.6.6.6
Table 25‐9 provides an explanation of the command output.
25-42 OSPFv3 Configuration
What It Displays...
Number of packets received with invalid packet type.
Columns listing packet types and number of packets sent and
received per type.
(Optional) Restricts the output display to a specific interface.
Specify the VLAN interface to display information about.
Specify the tunnel interface to display
(Optional) Specify the neighbor by its router ID, specified in 32‐bit
dotted quad format.
Priority Intf Interface
ID
-------- ----- -----------
1 3 Vlan 36
1 456 Tunnel 0
State Dead
Time
---------------- ----
Full/DR 32
Full/PtP 31