Save Config; Dir - Enterasys SECURESTACK C3 Configuration Manual

Parameters
auto
manual
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the configuration persistence mode to manual:
C3(su)->set snmp persistmode manual

save config

Use this command to save the running configuration. If applicable, this command will save the
configuration to all switch members in a stack.
Syntax
save config
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to save the running configuration:
C3(su)->save config

dir

Use this command to list configuration and image files stored in the file system.
Syntax
dir [filename]
Sets the configuration persistence mode to automatic. This is the default
state.
Sets the configuration persistence mode to manual. In order to make
configuration changes persistent, the save config command must be
issued as described in "save config" on page 3‐41. This mode is useful for
reverting back to old configurations.
SecureStack C3 Configuration Guide 3-41
save config