Table of Contents
Advertisement
Mode
Switch command, read‐write.
Example
This example shows how to set the method used to acquire a network IP address to DHCP.
C3(su)->set ip protocol dhcp
show system
Use this command to display system information, including contact information, power and fan
tray status and uptime.
Syntax
show system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display system information:
C3(su)->show system
System contact:
System location:
System name:
Switch 1
--------
PS1-Status
----------
Ok
Fan1-Status
-----------
Ok
Temp-Alarm
-----------
off
Thermal Threshold: 58%
Temp alarm max threshold:
Temp alarm trap: disabled
Temp alarm syslog: disabled
Uptime d,h:m:s
--------------
0,20:36:49
PS2-Status
----------
Not Installed and/or Not Operating
Fan2-Status
-----------
Ok
100%
Logout
-------
0 min
SecureStack C3 Configuration Guide 3-13
show system
- Quick Links:
- Set Ip Address
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SECURESTACK C3 and is the answer not in the manual?
Questions and answers