Set Igmpsnooping Remove-Static; Show Igmpsnooping Static - Enterasys SECURESTACK C3 Configuration Manual

If modify is not specified, a new entry is created.
Mode
Switch command, read‐write.
Usage
Use this command to create and configure static Layer 2 IGMP entries. Currently, up to 100 static
groups can be configured. A total of 256 dynamic and static IGMP groups are supported.
Example
This example creates an IGMP entry for the multicast group with IP address of 233.11.22.33
configured on VLAN 20 configured with the port ge.1.1.
C3(su)->set igmpsnooping add-static 233.11.22.33 20 ge.1.1

set igmpsnooping remove-static

This command deletes a static IGMP entry or removes one or more new ports from an existing
entry.
Syntax
set igmpsnooping remove-static group vlan-list [modify] [port-string]
Parameters
group
vlan‐list
modify
port‐string
Defaults
If no ports are specified, all ports are removed from the entry.
Mode
Switch command, read‐write.
Example
This example removes port ge.1.1 from the entry for the multicast group with IP address of
233.11.22.33 configured on VLAN 20.
C3(su)->set igmpsnooping remove-static 233.11.22.33 20 ge.1.1

show igmpsnooping static

This command displays static IGMP ports for one or more VLANs or IGMP groups.
Syntax
show igmpsnooping static vlan-list [group group]
Specifies the multicast group IP address of the entry.
Specifies the VLANs on which the entry is configured.
(Optional) Removes the specified port or ports from an existing entry.
(Optional) Specifies the port or ports to remove from the entry.
set igmpsnooping remove-static
SecureStack C3 Configuration Guide 13-7