Ip Rip Enable; Distance - Enterasys SECURESTACK C3 Configuration Manual

Mode
Global configuration: C3(su)‐>router(Config)#
Usage
You must execute the router rip command to enable the protocol before completing many RIP‐
specific configuration tasks. For details on enabling configuration modes, refer to Table
"Enabling Router Configuration Modes" on page 18‐2.
Example
This example shows how to enable RIP:
C3(su)->router#configure
C3(su)->router(Config)#router rip
C3(su)->router(Config-router)#

ip rip enable

Use this command to enable RIP on an interface. The no form of this command disables RIP on an
interface: By default, RIP is disabled on all interfaces.
Syntax
ip rip enable
no ip rip enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C3
Example
This example shows how to enable RIP on the VLAN 1 interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip rip enable

distance

Use this command to configure the administrative distance for RIP routes. The no form of this
command resets RIP administrative distance to the default value of 120.
Syntax
distance weight
no distance [weight]
(su)‐>router(Config‐if(Vlan 1))#
SecureStack C3 Configuration Guide 20-3
ip rip enable
18‐2 in