Ipv6 Ospf Dead-Interval - Enterasys SECURESTACK C3 Configuration Manual

Parameters
cost
Defaults
The default cost is 10.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Usage
Use this command to explicitly specify the cost of sending a packet on the interface being
configured for OSPFv3. Use the no form of this command to return the cost to the default value of
10.
Example
This example configures the cost for router interface VLAN 7 to 100.
C3(su)->router(Config)# interface vlan 7
C3(su)->router(Config-if(Vlan 7))# ipv6 ospf cost 100

ipv6 ospf dead-interval

This command sets the OSPFv3 dead interval for the router interface.
Syntax
ipv6 ospf dead-interval seconds
no ipv6 ospf dead-interval seconds
Parameters
seconds
Defaults
The default dead interval value is 40 seconds.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Usage
The OSPFv3 dead interval is the length of time in seconds that a router's Hello packets have not
been seen before its neighbor routers declare that the router is down. The value for the dead
interval must be the same for all routers attached to a common network, and should be some
multiple of the hello interval.
Use the no form of this command to return the dead interval to the default value of 40 seconds.
Specifies the cost of sending a packet on this interface. The value can
range from 1 to 65535.
Specifies the OSPFv3 dead interval in seconds. The value can range
from 1 to 2147483647 seconds.
ipv6 ospf dead-interval
SecureStack C3 Configuration Guide 25-23