Clear Host Vlan - Enterasys SECURESTACK C3 Configuration Manual

Stackable switches

Hide thumbs Also See for SECURESTACK C3:

Table of Contents

Switch command, read‐write.

The host VLAN should be a secure VLAN where only designated users are allowed access. For

example, a host VLAN could be specifically created for device management. This would allow a

management station connected to the management VLAN to manage all ports on the device and

make management secure by preventing management via ports assigned to other VLANs.

This example shows how to set VLAN 7 as the host VLAN:

C3(su)->set host vlan 7

clear host vlan

Use this command to reset the host VLAN to the default setting of 1.

clear host vlan

Switch command, read‐write.

This example shows how to set the host VLAN to the default setting:

C3(su)->clear host vlan

Specifies the number of the VLAN to set as the host VLAN.

Note: Before you can designate a VLAN as the host VLAN, you must create a VLAN using the set

of commands described in

"Creating and Naming Static VLANs" on page

SecureStack C3 Configuration Guide 10-19

clear host vlan

Show Quick Links

Table of Contents

Do you have a question about the SECURESTACK C3 and is the answer not in the manual?