Table of Contents
Advertisement
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables address allocation for BOOTP clients.
C3(rw)->set dhcp bootp enable
set dhcp conflict logging
Use this command to enable conflict logging. By default, conflict logging is enabled. Use the clear
dhcp conflict logging command to disable conflict logging.
Syntax
set dhcp conflict logging
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables DHCP conflict logging.
C3(rw)->set dhcp conflict logging
show dhcp conflict
Use this command to display conflict information, for one address or all addresses.
Syntax
show dhcp conflict [address]
Parameters
address
Defaults
If no address is specified, conflict information for all addresses is displayed.
[Optional] Specifies the address for which to display conflict information.
set dhcp conflict logging
SecureStack C3 Configuration Guide 16-5
- Quick Links:
- Set Ip Address
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SECURESTACK C3 and is the answer not in the manual?
Questions and answers