Clear Multiauth Port; Authentication Capacities - Enterasys SECURESTACK C3 Configuration Manual

clear multiauth port

Parameters
mode
auth‐opt |
auth‐reqd |
force‐auth |
force‐unauth
numusers
numusers
port‐string
Defaults
Default value for the number of users allowed to authenticate on a port is 1.
Mode
Switch command, read‐write.
Examples
This example shows how to set the port multiple authentication mode to required on
C3(rw)->set multiauth port mode auth-reqd ge.3.14
This example shows how to set the number of users allowed to authenticate on port
C3(rw)->set multiauth port numusers 2 ge.3.14
clear multiauth port
Use this command to clear multiple authentication properties for one or more ports.
Syntax
clear multiauth port {mode | numusers} port-string
Parameters
mode
numusers
port‐string
Defaults
None.
26-42 Authentication and Authorization Configuration
Specifies the port(s)' multiple authentication mode as:
• auth‐opt — Authentication optional ("non‐strict" behavior). If a user
does not attempt to authenticate using 802.1x, or if 802.1x
authentication fails, the port will allow traffic to be forwarded
according to the defined default VLAN.
• auth‐reqd — Authentication is required.
• force‐auth — Authentication considered.
• force‐unauth — Authentication disabled.
Specifies the number of users allowed authentication on port(s). Valid
values depend on your specific platform. Refer to Appendix A, Policy and
Authentication Capacities for information about multi‐user capacities.
Specifies the port(s) on which to set multiple authentication properties.
Clears the specified port's multiple authentication mode.
Clears the value set for the number of users allowed authentication on the
specified port.
Specifies the port or ports on which to clear multiple authentication
properties.
.3.14:
ge
.3.14 to 2:
ge