Set Port Txq - Enterasys SECURESTACK C3 Configuration Manual

set port txq

Example
This example shows how to display the current algorithm and transmit queue weights configured
on port ge.1.10:
C3(su)->show port txq
Port
-----
ge.
1.10 WRR 10
set port txq
Use this command to set QoS transmit queue arbitration values for physical ports.
Syntax
set port txq port-string value0 value1 value2 value3 value4 value5 value6 value7
Parameters
port‐string
value0 ‐ value7
Defaults
None.
Mode
Switch command, read‐write.
Usage
Queues can be set for strict priority (SP) or weighted round‐robin (WRR). If set for WRR mode,
weights may be assigned to those queues with this command. Weights are specified in the range of
0 to 100 percent. Weights specified for queues 0 through 7 on any port must total 100 percent.
Examples
This example shows how to change the arbitration values for the eight transmit queues belonging
to ge.1.1:
C3(su)->set port txq
This example shows how to change the algorithm to strict priority for the eight transmit queues
belonging to ge.1.1:
C3(su)->set port txq
C3(su)->show port txq
Port
-----
ge.
1.1
12-8 Port Priority Configuration
ge.
1.10
Alg Q0 Q1 Q2 Q3
--- --- --- --- --- --- --- --- ---
10 15 20
Specifies port(s) on which to set queue arbitration values. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 7‐1.
Only physical ports can be configured with this command. LAG ports
cannot be configured.
Specifies percentage to allocate to a specific transmit queue. The values
must total 100 percent.
ge.
1.1 10 10 10 10 10 10 10 30
ge.
1.1 0 0 0 0 0 O O 100
ge.
1.1
Alg Q0 Q1 Q2 Q3
--- --- --- --- --- --- --- --- ---
STR SP SP SP SP
Q4 Q5 Q6 Q7
25 20 0 0
Q4 Q5 Q6 Q7
SP SP SP SP