Ip Vrrp Authentication-Key; Show Ip Vrrp - Enterasys SECURESTACK C3 Configuration Manual

ip vrrp authentication-key

ip vrrp authentication-key
Use this command to enable or disable a VRRP authentication key (password) for use on an
interface. The no form of this command prevents VRRP from using authentication.
Syntax
ip vrrp authentication-key name
no ip vrrp authentication-key
Parameters
name
Defaults
None.
Mode
Interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the VRRP authentication key chain to "password" on the VLAN 1
interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip vrrp authentication-key password

show ip vrrp

Use this command to display VRRP routing information.
Syntax
show ip vrrp
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display VRRP information
C3(su)->router(Config)#show ip vrrp
-----------VRRP CONFIGURATION-----------
Vlan
2
20-48 IPv4 Routing Protocol Configuration
Specifies the password to enable or disable for VRRP authentication.
Vrid State Owner
1 Initialize
AssocIpAddr Priority
0 25.25.2.1 100