Enable - Enterasys SECURESTACK C3 Configuration Manual

Mode
Router configuration: C3(su)‐>router(Config‐router)#
Usage
Preempt is enabled on VRRP routers by default, which allows a higher priority backup router to
preempt a lower priority master.
The router that owns the virtual router IP address always preempts other routers, regardless of
this setting.
Example
This example shows how to disable preempt mode on the VLAN 1 interface, VRID 1:
C3(su)->router(Config)#router vrrp
C3(su)->router(Config-router)#no preempt vlan 1 1

enable

Use this command to enable VRRP on an interface. The no form of this command disables VRRP
on an interface.
Syntax
enable vlan vlan-id vrid
no enable vlan vlan-id vrid
Parameters
vlan vlan‐id
vrid
Defaults
None.
Mode
Router configuration: C3(su)‐>router(Config‐router)#
Example
This example shows how to enable VRRP on the VLAN 1 interface, VRID 1:
C3(su)->router(Config)#router vrrp
C3(su)->router(Config-router)#enable vlan 1 1
Specifies the number of the VLAN on which to enable VRRP. This VLAN
must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 18‐1.
Specifies the Virtual Router ID (VRID) associated with the vlan‐id. Valid
values are from 1 to 255.
SecureStack C3 Configuration Guide 20-47
enable