Dhcp Snooping Commands; Set Dhcpsnooping - Enterasys SECURESTACK C3 Configuration Manual

DHCP Snooping Commands

DHCP Snooping Commands
For information about...

set dhcpsnooping

set dhcpsnooping vlan
set dhcpsnooping database write-delay
set dhcpsnooping trust
set dhcpsnooping binding
set dhcpsnooping verify
set dhcpsnooping log-invalid
set dhcpsnooping limit
show dhcpsnooping
show dhcpsnooping database
show dhcpsnooping port
show dhcpsnooping binding
show dhcpsnooping statistics
clear dhcpsnooping binding
clear dhcpsnooping statistics
clear dhcpsnooping database
clear dhcpsnooping limit
set dhcpsnooping
Use this command to enable or disable DHCP snooping globally.
Syntax
set dhcpsnooping {enable | disable}
Parameters
enable
disable
Defaults
Disabled globally.
Mode
Switch command, read‐write.
Usage
By default, DHCP snooping is disabled globally and on all VLANs. You must enable it globally
with this command, and then enable it on specific VLANs.
17-4 DHCP Snooping and Dynamic ARP Inspection
Enable DHCP snooping globally on the switch.
Disable DHCP snooping globally on the switch.
Refer to page...
17-4
17-5
17-5
17-6
17-7
17-7
17-8
17-9
17-10
17-11
17-11
17-12
17-13
17-14
17-14
17-14
17-15