Default Conditions - Enterasys SECURESTACK C3 Configuration Manual

Overview
semantics. LSA scope is generalized to link, area, and AS scope. OSPFv3 specifies the processing
of unsupported LSAs. Unsupported LSAs are maintained in the database and flooded according
to scope. In OSPFv3, routers with 100 or more interfaces generate more than one router LSA. A
new link LSA has been created. Addresses in LSAs are specified as [prefix, prefix length].
Area ID and Router ID remain 32 bit identifiers. OSPFv3 identifies Neighbors by router ID instead
of the interface address used in OSPFv2.
Note that both OSPFv3 and OSPFv2 can be enabled and run on the SecureStack C3.

Default Conditions

The following table lists the default OSPFv3 conditions.
Condition
IPv6 OSPF
IPv6 OSPF cost
IPv6 OSPF dead-interval
IPv6 OSPF hello-interval
IPv6 OSPF mtu-ignore
IPv6 OSPF network
IPv6 OSPF priority
IPv6 OSPF retransmit-interval
IPv6 OSPF transmit-delay
Area stub no-summary
Area virtual-link dead-interval
Area virtual-link hello-interval
Area virtual-link retransmit-interval
Area virtual-link transmit-delay
Default-information originate
Distance OSPF
Administrative mode of OSPF
Exit-overflow-interval
External-lsdb-limit
Maximum-paths
Redistribute
Trapflags
25-2 OSPFv3 Configuration
Default Value
Disabled
10
40 seconds
10 seconds
Enabled
Broadcast
1
4
1
Enabled
40
10
5
1
Metric — unspecified
Type — 2
Intra — 8
Inter — 10
Type-1 — 13
Type-2 — 50
Enabled
0
-1
4
Metric — unspecified
Type — 2
Tag — 0
Enabled