Mnemonic Values For Logging Applications - Enterasys SECURESTACK C3 Configuration Manual

set logging application
Parameters
mnemonic
all
level level
Table 14-3
Mnemonic
CLIWEB
SNMP
STP
Driver
System
Stacking
UPN
Router
Defaults
If level is not specified, none will be applied.
Mode
Switch command, read‐write.
14-8 Logging and Network Management
Specifies a case sensitive mnemonic abbreviation of an application to be
logged. This parameter will vary depending on the number and types of
applications running on your system. To display a complete list, use the
show logging application command as described in "show logging
application" on page 14‐6. Sample mnemonics and their corresponding
applications are listed in Table
Note: Mnemonic values are case sensitive and must be typed as they appear in
Table 14-3.
Sets the logging severity level for all applications.
(Optional) Specifies the severity level at which the server will log
messages for applications. Valid values and corresponding levels are:
1 — emergencies (system is unusable)
2 — alerts (immediate action required)
3 — critical conditions
4 — error conditions
5 — warning conditions
6 — notifications (significant conditions)
7 — informational messages
8 — debugging messages

Mnemonic Values for Logging Applications

Application
Command Line Interface and Webview management
Simple Network Management Protocol
Spanning Tree Protocol
Hardware drivers
Non-application items such as general chassis management
Stacking management (if applicable)
User Personalized Networking
Router
14‐3 on page 14‐8.