Table of Contents
Advertisement
tunnel destination
tunnel destination
This command specifies the IPv4 destination transport address of the tunnel.
Syntax
tunnel destination ipv4-addr
no tunnel destination
Parameters
ipv4‐addr
Defaults
None.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Tnnl 1))#
Usage
The no form of this command removes the destination IPv4 address for the tunnel interface being
configured.
Example
The following example configures the destination IPv4 address for tunnel 1.
C3(su)->router(Config)# interface tunnel 1
C3(su)->router(Config-if(Tnnl 1))#
(su)->router(Config-if(Tnnl 1))# tunnel destination 192.168.10.20
C3
tunnel mode
This command specifies the mode of the tunnel interface.
Syntax
tunnel mode ipv6ip
no tunnel mode ipv6ip
Parameters
ipv6ip
Defaults
None.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Tnnl 1))#
Usage
The no form of this command removes the mode of the tunnel.
19-10 IP Configuration
The IPv4 destination address of the tunnel.
Specifies that the tunnel mode is IPv6 over IPv4
- Quick Links:
- Set Ip Address
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SECURESTACK C3 and is the answer not in the manual?
Questions and answers