No Ip Routing - Enterasys SECURESTACK C3 Configuration Manual

Mode
Interface configuration: C3
Usage
The shutdown form of this command disables an interface for IP routing.
Example
This example shows how to enable VLAN 1 for IP routing:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#no shutdown

no ip routing

Use this command to disable IP routing on the device. By default, IP routing is enabled when
interfaces are configured for it as described in "Configuring Routing Interface Settings" on
page 19‐1.
Syntax
no ip routing
Parameters
None.
Mode
Global configuration: C3(su)‐>router(Config)#
Defaults
None.
Example
This example shows how to disable IP routing on the device:
C3(su)->router(Config)#no ip routing
(su)‐>router(Config‐if(Vlan 1))#
SecureStack C3 Configuration Guide 19-7
no ip routing