Ipv6 Ospf Transmit-Delay - Enterasys SECURESTACK C3 Configuration Manual

Parameters
seconds
Defaults
Default value is 4 seconds.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Usage
The retransmit interval is the number of seconds between link‐state advertisement
retransmissions for adjacencies belonging to this router interface. This value is also used when
retransmitting database description and link‐state request packets.
Use the no form of this command to reset the retransmit interval to the default value of 4 seconds.
Example
This example sets the retransmit interval to 10 seconds for router interface VLAN 7.
C3(su)->router(Config)# interface vlan 7
C3(su)->router(Config-if(Vlan 7))# ipv6 ospf retransmit-interval 10

ipv6 ospf transmit-delay

This command sets the OSPFv3 transmit delay for the router interface.
Syntax
ipv6 ospf transmit-delay seconds
no ipv6 ospf transmit-delay
Parameters
seconds
Defaults
Default value is 1 second.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Usage
The transmit delay, specified in seconds, sets the estimated number of seconds it takes to transmit
a link state update packet over this interface.
Use the no form of this command to return the transmit delay to the default value of 1 seconds.
Specifies the retransmit interval value, which can range from 0 to 3600
seconds.
Specifies the transmit delay, which can range from 1 to 3600 seconds.
ipv6 ospf transmit-delay
SecureStack C3 Configuration Guide 25-27