Show Lacp - Enterasys SECURESTACK C3 Configuration Manual

For information about...
set lacp singleportlag
clear lacp singleportlag
show port lacp
set port lacp
clear port lacp

show lacp

Use this command to display information about one or more aggregator ports.
Syntax
show lacp [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, link aggregation information for all LAGs will be displayed.
Mode
Switch command, read‐only.
Usage
Each SecureStack C3 module provides 6 virtual link aggregator ports, which are designated in the
CLI as lag.0.1 through lag.0.6. Once underlying physical ports (that is, ge.x.x) are associated with
an aggregator port, the resulting aggregation will be represented as one Link Aggregation Group
(LAG) with a lag.x.x port designation.
Example
This example shows how to display lacp information for lag.0.1
output fields.
C3(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs:
Aggregator: lag.0.1
System Identifier:
System Priority:
Attached Ports:
Table 7‐7 provides an explanation of the command output.
(Optional) Displays LACP information for specific LAG port(s). Valid
port designations are lag.0.1 ‐ 6.
Actor
00:01:F4:5F:1E:20
Admin Key:
Oper Key:
ge.1.1
ge.1.3
disabled
Partner
00:11:88:11:74:F9
32768
32768
32768
Refer to page...
7-50
7-49
7-51
7-52
7-54
.
The following table describes the
32768
0
SecureStack C3 Configuration Guide 7-45
show lacp