Show Ipv6 Ospf Interface - Enterasys SECURESTACK C3 Configuration Manual

show ipv6 ospf interface

Table 25-6 show ipv6 ospf database database-summary Output Details (Continued)
Output Field
Link Unknown
Area Unknown
AS Unknown
Self Originated Type-7
Type-5 Ext
Self-Originated Type-5
Total
show ipv6 ospf interface
This command displays information about OSPFv3 interfaces.
Syntax
show ipv6 ospf interface {vlan vlanid | tunnel tunnelid | loopback loopid}
Parameters
vlan vlanid
tunnel tunnelid
loopback loopid
Defaults
None.
Mode
Router privileged execution: C3(su)‐>router#
Examples
This example displays information about OSPFv3 routing interface VLAN 80.
C3(su)->router>show ipv6 ospf interface vlan 80
IPv6 Address
ifIndex
OSPF Admin Mode
OSPF Area ID
Router Priority
Retransmit Interval
Hello Interval
Dead Interval
LSA Ack Interval
Iftransit Delay Interval
25-38 OSPFv3 Configuration
What It Displays...
Total number of link-source unknown LSAs in the OSPFv3 link
state database.
Total number of area unknown LSAs in the OSPFv3 link state
database.
Total number of as unknown LSAs in the OSPFv3 link state
database.
Total number of self-originated NSSA External Link-State
Advertisements in the OSPFv3 link state database.
Total number of AS external LSAs in the OSPFv3 link state
database.
Total number of self originated AS external LSAs in the OSPFv3
link state database.
Total number of router LSAs in the OSPFv3 link state database.
Specifies the VLAN interface to display information about.
Specifies the tunnel interface to display information about.
Specifies the loopback interface to display information about.
FE80::211:88FF:FE56:5D8F
430
Enable
0.0.0.20
1
5
10
40
1
1