Interface Configuration Commands; Purpose; Commands; Ipv6 Dhcp Server - Enterasys SECURESTACK C3 Configuration Manual

Interface Configuration Commands

Interface Configuration Commands

Purpose

These commands are used to configure an interface as either a DHCPv6 server or a DHCPv6 relay
agent.

Commands

For information about...

ipv6 dhcp server

ipv6 dhcp relay
ipv6 dhcp server
This command configures DHCPv6 server functionality on an interface.
Syntax
ipv6 dhcp server pool-name [rapid-commit} [preference pref]
no ipv6 dhcp server pool-name
Parameters
pool‐name
rapid‐commit
preference pref
Defaults
By default, DHCPv6 functionality is disabled.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Usage
Use this command to configure DHCPv6 server parameters when an interface will act as a
DHCPv6 server. Address pools are configured using the commands described in section "Address
Pool Configuration Commands" on page 24‐6.
An interface can be configured as either a DHCPv6 server or a DHCPv6 relay agent, but not both.
Use the no form of this command to remove DHCPv6 server functionality from an interface.
24-10 DHCPv6 Configuration
Specifies the pool containing stateless and/or prefix delegation
parameters that should be used by the DHCPv6 server. Refer to
"Address Pool Configuration Commands" on page 24‐6 for the
commands to configure an address pool.
(Optional) Specify that the server should use the Rapid Commit option
that allows for an abbreviated exchange between DHCPv6 client and
server. Refer to RFC 3315 for more information.
(Optional) Specifies the value of the server's Preference option. This
value, which can range from 0 to 4,294,967,295, is used by clients to
determine preference among multiple DHCPv6 servers.
Refer to page...
24-10
24-11