set system enhancedbuffermode
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to display enhanced buffer mode status:
C3(su)->show system enhancedbuffermode enable
Optimized system buffer distribution
set system enhancedbuffermode
Use this command to enable or disable enhanced buffer mode, which optimizes buffer
distribution into a single CoS queue operation for standalone switches or non‐stacked switches.
Executing this command will reset the switch, so the system prompts you to confirm whether you
want to proceed.
Syntax
set system enhancedbuffermode {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable enhanced buffer mode:
C3(su)->set system enhancedbuffermode enable
Changes in the enhanced buffer mode will require resetting this unit.
Are you sure you want to continue? (y/n)
set system temperature
Use this command to set the system high temperature threshold limit and the high temperature
alert parameters, on the platforms that support this feature.
Syntax
set system temperature {[syslog enable | disable] [trap enable | disable]
[overtemp-threshold value]}
3-18 Basic Configuration
Enables or disables enhanced buffer mode.
Disable