Configuring Simple Network Time Protocol (Sntp); Show Sntp - Enterasys SECURESTACK C3 Configuration Manual

Example
This example enables multicast flood protection.
C3(su)->set mac unreserved-flood enable

Configuring Simple Network Time Protocol (SNTP)

Purpose
To configure the Simple Network Time Protocol (SNTP), which synchronizes device clocks in a
network.
Commands
For information about...

show sntp

set sntp client
clear sntp client
set sntp server
clear sntp server
set sntp poll-interval
clear sntp poll-interval
set sntp poll-retry
clear sntp poll-retry
set sntp poll-timeout
clear sntp poll-timeout
set timezone
show sntp interface
set sntp interface
clear sntp interface
show sntp
Use this command to display SNTP client settings.
Syntax
show sntp
Note: A management IP (host, routing interface, or loopback) address must be configured for SNTP
to work..
Configuring Simple Network Time Protocol (SNTP)
Refer to page...
SecureStack C3 Configuration Guide 14-29
14-29
14-31
14-31
14-32
14-32
14-33
14-33
14-34
14-34
14-35
14-35
14-36
14-37
14-37
14-38