Clear Logging Server; Show Logging Default - Enterasys SECURESTACK C3 Configuration Manual

clear logging server

Defaults
If ip‐addr is not specified, an entry in the Syslog server table will be created with the specified
index number and a message will display indicating that no IP address has been assigned.
If not specified, facility, severity and port will be set to defaults configured with the set logging
default command ("set logging default" on page 14‐5).
If state is not specified, the server will not be enabled or disabled.
Mode
Switch command, read‐write.
Example
This command shows how to enable a Syslog server configuration for index 1, IP address
134.141.89.113, facility local4, severity level 3 on port 514:
C3(su)->set logging server 1 ip-addr 134.141.89.113 facility local4 severity 3
port 514 state enable
clear logging server
Use this command to remove a server from the Syslog server table.
Syntax
clear logging server index
Parameters
index
Defaults
None.
Mode
Switch command, read‐write.
Example
This command shows how to remove the Syslog server with index 1 from the server table:
C3(su)->clear logging server 1

show logging default

Use this command to display the Syslog server default values.
Syntax
show logging default
Parameters
None.
14-4 Logging and Network Management
Specifies the server table index number for the server to be removed.
Valid values are 1 ‐ 8.