show tacacs interface
Defaults
None.
Mode
Switch command, Read‐Write.
Examples
This example shows how to disable sending multiple requests over a single connection.
C3(rw)->set tacacs singleconnect disable
show tacacs interface
Use this command to display the interface used for the source IP address of the TACACS+ packets
generated by the switch.
Syntax
show tacacs interface
Parameters
None.
Defaults
None.
Mode
Switch mode, read‐only.
Example
This example displays the output of this command. In this case, the IP address assigned to
loopback interface 1 will be used as the source IP address of the TACACS+ packets generated by
the switch.
C3(rw)->show tacacs interface
loopback 1
set tacacs interface
Use this command to specify the interface used for the source IP address of the TACACS+ packets
generated by the switch.
Syntax
set tacacs interface {loopback loop-ID | vlan vlan-ID}
Parameters
loopback loop‐ID
192.168.10.1
Specifies the loopback interface to be used. The value of loop‐ID can
range from 0 to 7.
TACACS+ Configuration
SecureStack C3 Configuration Guide 27-11