Clear Snmp Access; Configuring Snmp Mib Views; Purpose; Commands - Enterasys SECURESTACK C3 Configuration Manual

clear snmp access

Use this command to clear the SNMP access entry of a specific group, including its set SNMP
security‐model, and level of security.
Syntax
clear snmp access groupname security-model {v1 | v2c | usm} [noauthentication |
authentication | privacy] [context context]
Parameters
groupname
security‐model v1 |
v2c | usm
noauthentication |
authentication |
privacy
context context
Defaults
If security level is not specified, all levels will be cleared.
If context is not specified, none will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to clear SNMP version 3 access for the "mis‐group" via the
authentication protocol:
C3(su)->clear snmp access mis-group security-model usm authentication

Configuring SNMP MIB Views

Purpose

To review and configure SNMP MIB views. SNMP views map SNMP objects to access rights.

Commands

For information about...
show snmp view
show snmp context
set snmp view
clear snmp view
Specifies the name of the SNMP group for which to clear access.
Specifies the security model to be cleared for the SNMP access group.
(Optional) Clears a specific security level for the SNMP access group.
(Optional) Clears a specific context for the SNMP access group. Enter / ‐ /
to clear the default context.
clear snmp access
Refer to page...
8-20
8-21
8-21
8-22
SecureStack C3 Configuration Guide 8-19