Show Cos Unit - Enterasys SECURESTACK C3 Configuration Manual

show cos unit

group‐type‐index
reference
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the CoS inbound rate limiting reference configuration for all
groups:
C3(su)->clear cos reference irl all
show cos unit
Use this command to show possible CoS unit entries.
Syntax
show cos unit [irl [port-type index] [kbps]] [flood-ctrl [port-type index] [pps]]
Parameters
irl
port‐type index
kbps
flood‐ctrl
pps
Defaults
If no parameters are entered, all Cos unit information is displayed.
Mode
Switch command, read‐only.
Examples
This example shows possible unit entries for inbound rate limiting
C3(su)->show cos unit irl
Type:
irl = inbound rate limiting
11-34 Policy Classification Configuration
Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
Clear a specific reference for the specified port group.
(Optional) Display only IRL unit information.
(Optional) Display information about the specified port type. (Only
port‐type index 0 is supported.)
(Optional) Display kbps information.
(Optional) Display only flood control unit information.
(Optional) Display pps information.
Unit:
Kbps
:
= Kilobits per second