Ip Irdp Broadcast; Show Ip Irdp - Enterasys SECURESTACK C3 Configuration Manual

ip irdp broadcast

Defaults
None.
Mode
Interface configuration: C3
Example
This example shows how to set IRDP preference on the VLAN 1 interface so that the interface's
address may still be advertised, but cannot be used by neighboring hosts as a default router
address:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip irdp preference -2147483648
ip irdp broadcast
Use this command to configure IRDP to use the limited broadcast address of 255.255.255.255. The
default is multicast with address 224.0.0.1. The no form of this command resets IRDP to use
multicast on IP address 224.0.0.1.
Syntax
ip irdp broadcast
no ip irdp broadcast
Parameters
None.
Defaults
None.
Mode
Interface configuration: C3
Example
This example shows how to enable broadcast for IRDP on the VLAN 1 interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip irdp broadcast

show ip irdp

Use this command to display IRDP information.
Syntax
show ip irdp [vlan vlan-id]
20-40 IPv4 Routing Protocol Configuration
(su)‐>router(Config‐if(Vlan 1))#
(su)‐>router(Config‐if(Vlan 1))#