Configuring Access Lists; Purpose; Commands; Show Access-Lists - Enterasys SECURESTACK C3 Configuration Manual

Configuring Access Lists

Configuring Access Lists

Purpose

To review and configure security access control lists (ACLs), which permit or deny access to
routing interfaces based on protocol and IP address restrictions.

Commands

For information about...

show access-lists

access-list (standard)
access-list (extended)
ip access-group
show access-lists
Use this command to display configured IP access lists when operating in router mode.
Syntax
show access‐lists [number]
Parameters
access‐list‐
number
Defaults
If number is not specified, the entire table of access lists will be displayed.
Mode
Any router mode.
Example
This example shows how to display IP access list number 145. This is an extended access list,
which permits or denies ICMP, UDP and IP frames based on restrictions configured with one of
the access‐list commands. For details on configuring standard access lists, refer to "access‐list
(standard)" on page 26‐83. For details on configuring extended access lists, refer to "access‐list
(extended)" on page 26‐84
26-82 Authentication and Authorization Configuration
Router: These commands can be executed when the device is in router mode only. For details
on how to enable router configuration modes, refer to
page 18-2.
Note: Refer to the Release Notes for your product for any limitations that may apply to access
control lists.
(Optional) Displays access list information for a specific access list number.
Valid values are between 1 and 199.
.
"Enabling Router Configuration
Refer to page...
26-82
26-83
26-84
26-86
Modes" on