Show Sntp Interface; Set Sntp Interface - Enterasys SECURESTACK C3 Configuration Manual

SNTP-Server
-------------------------------------------
192.255.255.254

show sntp interface

Use this command to display the interface used for the source IP address of the SNTP client.
Syntax
show sntp interface
Parameters
None.
Defaults
None.
Mode
Switch mode, read‐only.
Example
This example displays the output of this command. In this case, the IP address assigned to
loopback interface 1 will be used as the source IP address of the SNTP client.
C3(rw)->show sntp interface
loopback 1

set sntp interface

Use this command to specify the interface used for the source IP address of the SNTP client.
Syntax
set sntp interface {loopback loop-ID | vlan vlan-ID}
Parameters
loopback loop‐ID
vlan vlan‐ID
Defaults
None.
Mode
Switch command, read‐write.
Precedence
2
192.168.10.1
Specifies the loopback interface to be used. The value of loop‐ID can
range from 0 to 7.
Specifies the VLAN interface to be used. The value of vlan‐ID can range
from 1 to 4093.
Status
Active
SecureStack C3 Configuration Guide 14-37
show sntp interface