Show Lldp - Enterasys SECURESTACK C3 Configuration Manual

Step
1.
2.
3.
4.
5.

show lldp

Use this command to display LLDP configuration information.
Syntax
show lldp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display LLDP configuration information.
C3(ro)->show lldp
Message Tx Interval
Message Tx Hold Multiplier : 4
Notification Tx Interval
MED Fast Start Count
Tx-Enabled Ports
Rx-Enabled Ports
Trap-Enabled Ports
MED Trap-Enabled Ports
Task
Configure global system LLDP parameters
Enable/disable specific ports to:
• Transmit and process received LLDPDUs
• Send LLDP traps
• Send LLDP-MED traps
Configure an ECS ELIN value for specific ports
Configure Network Policy TLVs for specific ports
Configure which optional TLVs should be sent by
specific ports. For example, if you configured an
ECS ELIN and/or Network Policy TLVs, you must
enable those optional TLVs to be transmitted on
the specific ports.
Command(s)
set lldp tx-interval
set lldp hold-multiplier
set lldp trap-interval
set lldp med-fast-repeat
clear lldp
set/clear lldp port status
set/clear lldp port trap
set/clear lldp port med-trap
set/clear lldp port location-info
set/clear lldp port network-policy
set/clear lldp tx-tlv
: 30
: 5
: 3
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
SecureStack C3 Configuration Guide 6-15
show lldp