Enterasys SECURESTACK C3 Configuration Manual page 580

redistribute
static
metric metric value
subnets
Mode
Router configuration: C3(su)‐>router(Config‐router)#
Defaults
If metric value is not specified, 1 will be applied.
If subnets is not specified, only non‐subnetted routes will be redistributed.
Example
This example shows how to redistribute routing information discovered through static routes will
be redistributed into RIP update messages:
C3(su)->router(Config)#router rip
C3(su)->router(Config-router)#redistribute static
20-10 IPv4 Routing Protocol Configuration
Specifies that non‐RIP routing information discovered via static routes will
be redistributed. Static routes are those created using the ip route
command detailed in "ip route" on page 19‐21.
(Optional) Specifies a metric for the connected, OSPF or static
redistribution route. This value should be consistent with the designation
protocol.
(Optional) Specifies that connected, OSPF or static routes that are
subnetted will be redistributed.