Commands; Show Snmp Access - Enterasys SECURESTACK C3 Configuration Manual

show snmp access

Commands

For information about...
show snmp access
set snmp access
clear snmp access
show snmp access
Use this command to display access rights and security levels configured for SNMP one or more
groups.
Syntax
show snmp access [groupname] [security-model {v1 | v2c | usm}] [noauthentication
| authentication | privacy] [context context] [volatile | nonvolatile | read-only]
Parameters
groupname
security‐model v1 |
v2c | usm
noauthentication |
authentication |
privacy
context context
volatile |
nonvolatile | read‐
only
Defaults
If groupname is not specified, access information for all SNMP groups will be displayed.
If security‐model is not specified, access information for all SNMP versions will be displayed.
If noauthentication, authentication or privacy are not specified, access information for all
security levels will be displayed.
If context is not specified, all contexts will be displayed.
If volatile, nonvolatile or read‐only are not specified, all entries of all storage types will be
displayed.
Mode
Switch command, read‐only.
8-16 SNMP Configuration
(Optional) Displays access information for a specific SNMPv3 group.
(Optional) Displays access information for SNMP security model version
1, 2c or 3 (usm).
(Optional) Displays access information for a specific security level.
(Optional) Displays access information for a specific context. For a
description of how to specify SNMP contexts, refer to "Using SNMP
Contexts to Access Specific MIBs" on page 8‐3.
(Optional) Displays access entries for a specific storage type.
Refer to page...
8-16
8-18
8-19