Set Ipv6 Gateway - Enterasys SECURESTACK C3 Configuration Manual

Mode
Switch mode, read‐write.
Usage
This command clears addresses manually configured with the set ipv6 address command. Use the
clear ipv6 gateway command to clear the IPv6 gateway address.
Example
This example illustrates that this command clears only those IPv6 addresses configured with the
set ipv6 address command. The link‐local address for the host interface and the gateway address
are not removed with this command.
C3(su)->show ipv6 address
Name
------------
host
host
host
gateway
C3(su)->clear ipv6 address all
C3(su)->show ipv6 address
Name
------------
host
gateway

set ipv6 gateway

Use this command to configure the IPv6 gateway (default router) address.
Syntax
set ipv6 gateway ipv6-addr
Parameters
ipv6‐addr
Defaults
None.
Mode
Switch mode, read‐write.
Usage
This command configures the IPv6 gateway address. Only one IPv6 gateway address can be
configured for the switch, so executing this command when a gateway address has already been
configured will overwrite the previously configured address.
IPv6 Address
----------------------------------------
FE80::201:F4FF:FE5C:2880/64
2001:DB8:1234:5555:201:F4FF:FE5C:2880/64
2001:DB8:1234:5555::9876:2/64
FE80::201:F4FF:FE5D:1234
IPv6 Address
----------------------------------------
FE80::201:F4FF:FE5C:2880/64
FE80::201:F4FF:FE5D:1234
The IPv6 address to be configured. The address can be a global unicast or
link‐local IPv6 address, in the form documented in RFC 4291, with the
address specified in hexadecimal using 16‐bit values between colons.
set ipv6 gateway
SecureStack C3 Configuration Guide 21-5