Clear Lldp Port Network-Policy - Enterasys SECURESTACK C3 Configuration Manual

clear lldp port network-policy

Example
This example returns the location information ELIN value on port ge.1.1 to the default value of
null.
C3(rw)->clear lldp port location-info elin ge.1.1
clear lldp port network-policy
Use this command to return LLDP network policy for a set of applications on a port or range of
ports to default values.
Syntax
clear lldp port network-policy {all | voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice | video-conferencing | streaming-video |
video-signaling} {[state] [tag] [vid] [cos] [dscp]} port-string
Parameters
all
voice
voice‐signaling
guest‐voice
guest‐voice‐signaling
softphone‐voice
video‐conferencing
streaming‐video
video‐signaling
state
tag
vid
cos
dscp
port‐string
Defaults
At least one application (or all) and one policy parameter must be specified.
Mode
Switch command, read‐write.
6-34 Discovery Protocol Configuration
Applies command to all applications.
Applies command to the voice application.
Applies command to the voice signaling application.
Applies command to the guest voice application.
Applies command to the guest voice signaling application.
Applies command to the softphone voice application.
Applies command to the video conferencing application.
Applies command to the streaming video application.
Applies command to the video signaling application.
(Optional) Clears the state of advertising the application
information being configured to disabled.
(Optional) Clears the tag value of the application being configured
to untagged.
(Optional) Clears the VLAN identifier for the port to the default
value of 1.
(Optional) Clears the Layer 2 priority to be used for the application
being configured to the default value of 0. (A value of 0 represents
use of the default priority as defined in IEEE 802.1D.)
(Optional) Clears the DSCP value to be used to provide Diffserv
node behavior for the application being configured to the default
value of 0. (A value of 0 represents use of the default DSCP value
as defined in RFC 2475.)
Specifies the port or range of ports to be affected.