Ip Igmp Access-Group - Dell Z9500 Command Reference Manual

ip igmp access-group

To specify access control for packets, use this feature.
Z9500
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list
command.
Parameters
access-list
Defaults Not configured
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
Usage The access list accepted is an extended ACL. To block IGMP reports from hosts, on
Information a per-interface basis based on the group address and source address that you
specify in the access list, use this feature.
ip igmp group-join-limit
To limit the number of IGMP groups that can be joined in a second, use this feature.
Z9500
Syntax
ip igmp group-join-limit number
Parameters
number
808
Enter the name of the extended ACL (16 characters
maximum).
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Enter the number of IGMP groups permitted to join in a
second. The range is from 1 to 10000.
Internet Group Management Protocol (IGMP)