Match Metric - Dell S4810 Reference Manual

match ip next-hop

match metric

match route-type
match tag
match metric
To match on a specified value, configure a filter.
S4810
Syntax
match metric metric-value
To delete a value, use the no match metric [metric-value] command.
Parameters
metric-value
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
Access Control Lists (ACL)
— redistributes routes that match the next-hop IP address.
— redistributes routes that match a specific metric.
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Enter a value to match. The range is from zero (0) to
4294967295.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match an IP address.
— redistributes routes that match the next-hop IP address.
279