Match Ip Route-Source - Dell S4810 Reference Manual

Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands
match ip address

match ip route-source

routers.
match metric
match route-type
match tag
match ip route-source
To match based on the routes advertised by routes specified in IP access lists or IP prefix lists, configure a
filter.
S4810
Syntax
match ip route-source {prefix-list prefix-list-name}
To delete a match, use the no match ip route-source {prefix-list
prefix-list-name} command.
Parameters
prefix-list
prefix-list-
name
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
276
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match an IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a specific metric.
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Enter the keywords prefix-list and then enter the name
of configured prefix list, up to 140 characters.
Access Control Lists (ACL)